Website StatiCAD-Support Knowledgebase
Post-Analysis Error Resolution
Suggested knowledgebase articles:

Knowledgebase Post-Analysis Error Resolution

Articles in this category

Error Percentage in Finite Element Analysis and Solutions

No structural element should have its length, thickness, or modulus of elasticity set to zero. Zero values for these parameters cause infinite displacement demand in the element. If the mass of eleme...
Finding Model Errors from Joint Displacements

After analyzing the project, the following procedure can be followed to determine whether there are errors in element connections or in the finite element model: 1- Performing the analysis with semi-...
Partial Error in Load Transfer

When an error occurs during vertical load transfer, the program displays a warning on the Analysis screen: "Partial error occurred in load transfer, Partial Error Ratio = %..." The most practical met...
Excluding RC Slab Calculations from Reports and Drawings

If there are slabs for which you do not want reinforcement calculations to be performed in the drawings, right-click on the relevant slabs and click the "Delete slab calculation axis" command from the...
Node Point Editing Operations

You can watch the video on node point (element endpoint definition points) editing operations in the StatiCAD program.